Why are the high-frequency characteristics of DC-Link capacitors more stringent in 800V electric drive platforms?

On an 800V platform, the inverter bus voltage is higher, and the switching frequency of SiC devices typically increases to the 20~100kHz range. High-frequency switching generates larger dv/dt and ripple current, significantly increasing the requirements for the capacitor's ESR, ESL, and resonant characteristics. If the capacitor's response is not timely, it will lead to increased bus voltage fluctuations and even induce voltage surges.

In an 800V platform, how can the specific advantages of DC-Link film capacitors over traditional aluminum electrolytic capacitors in high-frequency response be quantified?

Film capacitors exhibit lower equivalent series resistance (ESR) at high frequencies, such as as low as 2.5mΩ at 50kHz, while aluminum electrolytic capacitors typically have ESRs ranging from tens to hundreds of mΩ. Lower ESR results in lower heat loss and higher dV/dt withstand capability, effectively suppressing voltage overshoot. Actual measurement data shows that under 800V/300A conditions, film capacitors can suppress voltage surge peaks to within 110% of the rated voltage, while aluminum electrolytic capacitors may exceed 130%.

How to design a surge voltage protection circuit for a DC-Link capacitor to prevent overvoltage breakdown caused by switching transients?

Surge protection requires consideration of capacitor selection and external circuit design. First, when selecting the rated voltage of the capacitor, allow for at least a 20% margin (e.g., use a 1000V capacitor for an 800V system). Secondly, add a transient voltage suppressor (TVS) or a varistor (MOV) to the busbar, with a clamping voltage slightly higher than the normal operating voltage. Simultaneously, utilize an RC snubber circuit connected in parallel with the switching device to absorb energy during the switching process.

Under a combined environment of 125℃ high temperature and 800V high voltage, the leakage current of a DC-Link capacitor increases from 1μA at room temperature to 50μA, exceeding the safety threshold. How to solve this?

Optimize the dielectric material formulation, increase the dielectric thickness (e.g., from 3μm to 5μm) to improve insulation performance; strictly control the cleanliness of the dielectric film during production to avoid impurities causing increased leakage current; vacuum dry the capacitor core before packaging to remove internal moisture and reduce humidity-induced leakage current.

In an 800V system, how to verify the long-term reliability of DC-Link capacitors, especially their lifespan under high voltage stress?

Reliability verification requires a combination of accelerated life testing and real-world operating condition simulation. First, conduct high-voltage stress testing: perform long-term aging tests (e.g., 1000 hours) at 1.2-1.5 times the rated voltage, monitoring capacitance drift, ESR increase, and leakage current changes. Second, apply the Arrhenius model for thermal accelerated testing, evaluating lifespan characteristics at high temperatures to extrapolate lifespan under actual operating conditions.

Blog

Te Whakatau i te Raru Ngaohiko i roto i ngā Pūwhakawhiti Puku Matua Pūngao Hou 800V – Otinga Pūnga Kiriata Hononga-DC YMIN MDP Series
nā te kaiwhakahaere i te 25-12-03
Momo Raru: Ngā Āhuatanga Auau-Teitei P: He aha i kaha ake ai ngā āhuatanga auau-teitei o ngā pūnga DC-Link i roto i...
Pānuihia atu
Te Pana i ngā Here: Ka Whakaratohia e ngā Pūngao Hiko Konumohe Ngaohiko-Tiketike YMIN LKC Raupapa -55℃ te Pūngao Pono mō ngā Taputapu i ngā Taiao Tino Kino
nā te kaiwhakahaere i te 25-12-01
I ngā mara ahumahi teitei pēnei i ngā taputapu hōia, ngā taputapu hiko tereina, me ngā puranga utu, kei te piki haere te aro o ngā taputapu ki te...
Pānuihia atu
Parenga Taumata-Mirihekona: YMIN Lithium-ion Supercapacitors Tiaki Pūnaha Hiko mō ngā Tūmau AI
nā te kaiwhakahaere i te 25-11-28
I tēnei wā o te tipu tere o te mana rorohiko AI, ka taea e te hekenga ngaohiko kotahi te whakararuraru i ngā mahi whakangungu, ka hua ake he tohu kino...
Pānuihia atu
Ngā Pūnga Hikohiko Konumohe Totoka Pūngao-Teitei a YMIN: Ka pakaru i ngā herenga o te wāhi tahora PCB, ka whakamana i te hoahoa o ngā pūnaha matihiko matatau-te-mana-teitei.
nā te kaiwhakahaere i te 25-11-27
I te whanaketanga tonu o ngā taputapu hikohiko kaihoko ki te whakaitiiti me te kiato mana teitei, ko te wāhi tahora PCB i runga i te matihiko atamai...
Pānuihia atu
[Aratohu Kōwhiri] Me pēhea te whakataurite i te ngaohiko teitei me te roa o te ora i roto i te OBC Miniaturization? Tātari Pūngao Ngaohiko Teitei YMIN LKD
nā te kaiwhakahaere i te 25-11-26
Pātai Matua: "Kāore i te nui te wāhi i taku papa OBC, ā, he nui rawa te wāhi e nohoia ana e ngā pūnga haona tuku iho. Kei te...
Pānuihia atu
Te Whakatau i te Raru Whakamahinga Mana Teitei o ngā Pūnaha OBC/DCDC: Te Whakakitenga i ngā Raraunga Ine o te Ao Tūturu o ngā Pūnga Whakapūnga Wai-Totoro YMIN
nā te kaiwhakahaere i te 25-11-21
Pātai Matua: He aha te take e kimo ai te papaaho o taku waka hiko hou i te wā e utu ana? Nā te pūngao putanga kore pumau rānei...
Pānuihia atu
Rahi Iti, Matauranga Nui: Ngā Pūnga Hiko o te Tarakona – Ngā Pūnga YMIN!
nā te kaiwhakahaere i te 25-11-19
Ko te pūnaha hiko o te waka rererangi rererangi iti e whakatau ana i tōna pumau me tōna haumaru rere, ā, ko te kōwhiringa pūnga iahiko he āhuatanga hangarau nui. Te waka rererangi iti...
Pānuihia atu
He Wā Hou i roto i te Whakamārama: Me pēhea te whakamārama a ngā Pūnga Iti o YMIN i tētahi Ao Mārama?
nā te kaiwhakahaere i te 25-11-12
Kei te huri haere te umanga rama mā te 30%, ā, kei te whakaroahia tōna roanga mahi i ngā wā maha. Haere ki roto i tētahi...
Pānuihia atu
Mā te whakaoti rapanga o te auau teitei, te ngaohiko teitei, me te pāmahana teitei, kua noho ngā Pūnga YMIN hei hoa pai rawa atu mō ngā semiconductors o te whakatupuranga tuatoru.
nā te kaiwhakahaere i te 25-11-10
Inanahi, ko te 4 o ngā Huihuinga me ngā Whakaaturanga mō ngā Hikohiko Mana me te Huringa Pūngao o Haina (CPEEC) me te 28 o ngā Huihuinga Mātauranga ā-Tau...
Pānuihia atu
Me pēhea e whakaoti ai ngā pūnga totoka-āhua YMIN i te wero tahora PCB o ngā pēke hiko kiato-teitei me te takai tino-angiangi?
nā te kaiwhakahaere i te 25-11-10
Kupu Whakataki I roto i te hoahoa taputapu hiko o nāianei, kei te piki haere te rerekētanga i waenga i te teitei o te PCB me te matotoru o te waea...
Pānuihia atu
He Kaiawhina Kaha mō ngā Pūnaha Hiko 5G! Me pēhea te tiaki a ngā Pūnga YMIN i te mahi o te Teihana Tūāpapa Pūmau
nā te kaiwhakahaere i te 25-11-07
He tino iti te ESR, he kaha te ātete ki ngā ngaru, ā, he tu atu ki ngā iahiko ngaru neke atu i te 20A—Kei te huri ngā Pūnga YMIN hei pou matua o ...
Pānuihia atu
He mihi nui ki a koutou a Shanghai YMIN Electronics ki te whakaaturanga CPEEC*CPSSC i Shenzhen hei tūhura i te ao auaha o ngā tono pūnga hiko mahi-teitei.
nā te kaiwhakahaere i te 25-11-07
Ka whakaatuhia e Shanghai YMIN Electronics āna otinga pūngao matatau i roto i ngā wāhanga matua pēnei i ngā waka hiko hou, ngā tūmau AI...
Pānuihia atu

<< < O mua 1 2 3 4 5 6 Panuku >>> Whārangi 4 / 24

Blog

Te Whakatau i te Raru Ngaohiko i roto i ngā Pūwhakawhiti Puku Matua Pūngao Hou 800V – Otinga Pūnga Kiriata Hononga-DC YMIN MDP Series

Te Pana i ngā Here: Ka Whakaratohia e ngā Pūngao Hiko Konumohe Ngaohiko-Tiketike YMIN LKC Raupapa -55℃ te Pūngao Pono mō ngā Taputapu i ngā Taiao Tino Kino

Parenga Taumata-Mirihekona: YMIN Lithium-ion Supercapacitors Tiaki Pūnaha Hiko mō ngā Tūmau AI

Ngā Pūnga Hikohiko Konumohe Totoka Pūngao-Teitei a YMIN: Ka pakaru i ngā herenga o te wāhi tahora PCB, ka whakamana i te hoahoa o ngā pūnaha matihiko matatau-te-mana-teitei.

[Aratohu Kōwhiri] Me pēhea te whakataurite i te ngaohiko teitei me te roa o te ora i roto i te OBC Miniaturization? Tātari Pūngao Ngaohiko Teitei YMIN LKD

Te Whakatau i te Raru Whakamahinga Mana Teitei o ngā Pūnaha OBC/DCDC: Te Whakakitenga i ngā Raraunga Ine o te Ao Tūturu o ngā Pūnga Whakapūnga Wai-Totoro YMIN

Rahi Iti, Matauranga Nui: Ngā Pūnga Hiko o te Tarakona – Ngā Pūnga YMIN!

He Wā Hou i roto i te Whakamārama: Me pēhea te whakamārama a ngā Pūnga Iti o YMIN i tētahi Ao Mārama?

Mā te whakaoti rapanga o te auau teitei, te ngaohiko teitei, me te pāmahana teitei, kua noho ngā Pūnga YMIN hei hoa pai rawa atu mō ngā semiconductors o te whakatupuranga tuatoru.

Me pēhea e whakaoti ai ngā pūnga totoka-āhua YMIN i te wero tahora PCB o ngā pēke hiko kiato-teitei me te takai tino-angiangi?

He Kaiawhina Kaha mō ngā Pūnaha Hiko 5G! Me pēhea te tiaki a ngā Pūnga YMIN i te mahi o te Teihana Tūāpapa Pūmau

He mihi nui ki a koutou a Shanghai YMIN Electronics ki te whakaaturanga CPEEC*CPSSC i Shenzhen hei tūhura i te ao auaha o ngā tono pūnga hiko mahi-teitei.

Ngā Pūnga Āwhina YMIN: Te Whakakaha i te Āhuarangi o Ngā Waka, Te Wetewete i tētahi Wā Hou ...

Ko te supercapacitor ranu SLF 4.0V 4500F e whakarato ana i te kaha pakari taumata-miritēkona...

Me pēhea te whiriwhiri i te Pūnga PLP Tino Pai mō ngā SSD Tūmau AI? He Māramatanga...

Te Whakatau i te Raruraru o te Pūnaha Hiko CPU/GPU i roto i ngā Tūmau AI: Me pēhea te Whakaū i te Nano...

Rahi Iti, Mana Nui! Ka Whakakahangia e ngā Pūnga YMIN te Whakamaroke Makawe Tere-Tiketike...

Poroporoaki ki te Paunga Hiko me te Wā Whakamutu: Te Raupapa Hiko SDB a YMIN...